Solar Outdoor Light Installation Guide

Solar Outdoor Light installation guide:

1. Before the lamp is installed, the lamp and its accessories should be complete, and there should be no mechanical damage, no deformation, paint peeling, lampshade cracking, and other defects.

2. The installation of lamps should be based on the installation site and use of the lamps and the wire cores of each lamp that meet the relevant regulations should be relatively small in section.

3. When installing lamps, it should also be noted that when the masonry structure is installed in the entire electrical lighting installation process, embedded hooks, bolts, screws, expansion bolts, nylon plugs, or plastic plugs should be used for fixing; wooden wedges are strictly prohibited. When the design is not specified, the bearing capacity of the above-mentioned fixing parts should match the weight of the electric lighting device.

4. In dangerous and special dangerous places, when the height of the lamps is less than 2.4 meters from the ground, the lighting lamps with a rated voltage of 36 volts and below should be used or protective measures should be taken. Lamps should not be installed directly on combustible objects; when the high-temperature part of the lamp surface is close to combustibles, measures for heat insulation and heat dissipation should be taken.