Low Voltage Outdoor String Lights Suppliers Introduces The Installation Rules Of Lamps And Lanterns

Low Voltage Outdoor String Lights Suppliers introduces the installation rules of lamps:

⒈Fix the components of each part: the solar panel is fixed on the solar panel bracket, the lamp holder is fixed to the arm, and then the bracket and the arm are fixed to the main pole, and the connecting wire is passed to the control box (battery box).
⒉Before lifting the lamp pole, check whether the fasteners of each part are firm, whether the lamp holder is installed correctly, and whether the light source works normally. Then check whether the system is working normally; loosen the solar panel connection line on the controller, and the light source works.
⒊Pay attention to safety precautions when hoisting the main light pole; the screws are absolutely fastened, if the component's sun-facing angle has deviated, you need to adjust its sun-facing direction to the south completely.
⒋Put the battery into the battery box, and connect the connecting wire to the controller according to the technical requirements; connect the battery, then the load, and then the solar panel; when wiring, be sure to pay attention to the wiring and the terminal marked on the controller. Wrong connection, the positive and negative polarities cannot collide, and cannot be reversed; otherwise, the controller will be damaged.
⒌Check whether the system is working properly; loosen the solar panel connection line on the controller, the light is on; connect the solar panel connection line, the light is off; at the same time, carefully observe the changes of the indicators on the controller; everything is normal before sealing the control box.